When I step through the channel on my T4 using the up/down rocker on the remote. the channel and program identification appear at the bottom of the screen for each channel (i.e. the indication of what is being broadcast in real-time and is on the screen).
Going into the EPG, the full list of channels is displayed in the left-hand column, as usual. However, initially, all the program info was blank. If I select a particular channel to view, after a while the program info becomes populated. However, this does not happen with Channel 9 and its associated channels - the EPG content is missing.
Is it just that I am not being patient enough and will have to wait for an extended period for the data to be transmitted and loaded into the EPG? Or is there a known problem that is causing this?
Thanks
Paul
St Kilda
T4 EPG not working on some channels
-
- Wizard God
- Posts: 32714
- Joined: Tue Sep 04, 2007 13:49
- Location: Canberra; Black Mountain Tower transmitters
Re: T4 EPG not working on some channels
You shouldn't have to wait more than about a minute on any channel for that channel's broadcaster's EPG to load fully.
You should only need to visit one channel from each broadcaster to fully load the EPG.
You should only need to visit one channel from each broadcaster to fully load the EPG.
Peter
T4 HDMI
U4, T4, T3, T2, V2 test/development machines
Sony BDV-9200W HT system
LG OLED55C9PTA 55" OLED TV
T4 HDMI
U4, T4, T3, T2, V2 test/development machines
Sony BDV-9200W HT system
LG OLED55C9PTA 55" OLED TV